MAINTENANCE
Checking and Adjusting
the Throttle Cable and the Choke
Cable
Kawasaki engine
Check that the engine responds to throttle increases and that a good engine speed is attained at full throttle.
If doubts arise, contact the Husqvarna service workshop.
If adjustments are necessary, they can be made as follows for the cable:
1.Loosen the clamping screw for the cable’s outer casing.
2.Check that the throttle cable is mounted in the correct hole in the lever.
3.Set the throttle lever to position full throttle with no choke.
4.Align the hole in the speed control lever with the hole in the base plate by moving the lever. Insert a 6 mm dia pin (or a screw) through the two holes.
5.Pull up the outer housing of the throttle cable until the inner wire has almost no slack and tighten the clamping screw.
6.Remove the 6 mm pin.
7.Make sure that the carburetor choke valve is closed completely when the throttle lever is moved to choke position.
8.Check engine idle speed.
Kohler engine
1.Loosen the clamping screw for the cable´s outer casing and move the throttle to the full choke position.
2.Ensure that full choke is applied at the carburetor by moving the outer casing by hand.
3.Tighten the clamping screw.
4.Start engine. Check idle rpm and choke function.
Adjusting the throttle cable