are not intended nor suitable for large motors or other external appliances.
BEFORE
SERVICING
Always disconnect Electrical Power at the Main Disconnect when servicing or replacing any electrical component.
This includes (but not limited to) Fans,
Heaters,Thermostats, and Lights.
Ballast
FIELD WIRING & SERIAL PLATE AMPERAGE
Field Wiring must be sized for component amperes printed on the serial plate.Actual ampere draw may be less than specified. Field wiring from the refrigeration
control panel to the merchandisers is required for refrigeration thermostats. Most component amperes are listed in the “Case Specs” section, but always check the serial plate.
Ballasts are located within the access panel that runs the length of the rear of the case. Refer to diagram below.
Maintenance
PLEXIGLASS & ACRYLIC CARE
Improper cleaning not only accelerates the cleaning cycle but also degrades the quality of this surface. Normal daily buffing motions can generated static cling attracting dust to the surface. Incorrect cleaning agents or cleaning cloths can cause micro scratching of the surface, causing the plastic to haze over time.
CLEANING
Hussmann recommends using a clean damp chamois, or a paper towel marked as dust and abrasive free with 210® Plastic Cleaner and Polish available by calling Sumner Labs at
Rev.1104
ANTISTATIC COATINGS
The 210® has proven to be very effective in not only cleaning and polishing the Plexiglass surface, but also providing antistatic and
CLEANING PRECAUTIONS
WHEN CLEANING:
Never Use a Cleaning or Sanitizing Solution that has an OIL BASE (these will dissolve the butyl sealants) or AMMONIA BASE
(this will corrode the copper components of the case)
TO PRESERVE THE ATTRACTIVE FINISH:
Do Use Water and a Mild Detergent for the Exterior Only!
Do Not Use Abrasives or Steel Wool Scouring Pads (these will mar the finish)
CLEANING GLASS & MIRRORS
Only use a soft cloth and mild glass cleaner for cleaning any glass or mirrored components. Be sure to rinse and/ or dry completely.
Never use hot water on cold glass surfaces! It may shatter and cause serious injury! Allow glass surfaces to warm
GLASS
The
While the anti reflective coatings are durable, they are susceptible to scratching if abrasive materials or liquids are used for cleaning. Once the glass surface is damaged, it is IMPOSSIBLE to restore it to the original finish. The following materials are recommended for routine cleaning:
Specialized cleaning cloths
•Scotch Brite @ High performance Cloth - manufac- tured by 3M and available in most grocery stores. This cloth is washable and may be reused as long as the cloth stays clean and free from solvents.
•Spontex® Microfibre Cleaning Cloth - distributed by Spontex® and available in most grocery stores under the same name.This cloth is washable and may be reused as long as the cloth stays clean and free from solvents.
The cleaning cloths named above will usually remove
5