I-JAM Multimedia 100 manual Operating your I-JAM

Operating your I-JAM:

1.Carefully insert an MMC (with MP3 music recorded on it), into the slot of your I-JAMMP3 Player, located at the bottom of the player.

2.Turn on your I-JAMMP3 Player by holding down your PWR button, for three seconds.

3.“Hello” will flash across the LCD screen several times, and then show “MP3 Mode,” and finally “MPEG

PLAY.”

4.If you do not insert an MMC, and turn the power on, the LCD screen will display, “NodSk.”

5.If you have properly installed the MMC, you will see the following LCD screen: -----

6.If you have inserted the MMC without the music recorded properly, your LCD screen will show, “NO FILE.”

7.If you have inserted the MMC with an incorrect file type, such as a .zip file, your LCD screen will show, “NO

FILE.”

8.To PAUSE the music, press the ----- button, located on the top right-hand corner of the I-JAMMP3 Player. The music will pause, and hold until you press the ----- button again. The music will then resume from where you paused it. ------

9.To STOP and RESET the music, press and hold the ---- button, located at the upper-right-hand corner of the I-JAMMP3 Player, for three seconds. The unit will reset to the beginning of the first track. -----

10.To adjust the VOLUME, press the VOL button. The ----- and ----- buttons will adjust the volume up or down, in increments between 1 and 20.

11.To utilize the independent BASS and TREBLE controls, hold down the VOL button for three seconds. “BASS” will first be displayed on the LCD screen. You can then adjust the BASS by using the ----- and -----

buttons. Press the volume button again, and “TREBLE” will display on the LCD screen. Again, use the -----

or ------ button to set the desired level.

Changing the Track:

If you would like to change the track that you are listening to, use -----	to move back one track, or the -----	to advance it.
You may back up or advance the track as many times as you like.

(A-B) Function:

The (A-B)button allows you to listen to any portion of the track, over, and over again. For example, if you would like to learn the chorus of a particular song, or write down the lyrics to a particular song, use this function. Push the (A-B)button at the beginning of the section that you want to listen to. Click it once again at the desired end. That part will begin to repeat until it is cleared. You can clear it by pushing the (A-B)button once again.

(RND) Random Play, 5-Second Introduction:

Select the random play mode by pressing the RND button. The recorded tracks will play at random until the button is pressed again. By holding down the RND button, for three seconds, a 5-second introduction of each track will be played. You can then select the track that you would like to listen to by pressing either the ----- or ----- button.

(RPT) Repeating a Track, (RPT ALL) Continuous Repeat:

Pressing the RPT button will repeat the last track that you were listening to. Pressing the RPT button again will continually repeat all of the tracks. To stop the repeat mode, press the RPT button again. The

I-JAMMP3 Player will go back to normal operation.

(MP/FM/HOLD) FM Radio Operation:

Select the FM operation by pressing MP/FM/HOLD button located on the top left-hand side of the I-JAMMP3 Player.

-----Pressing the ----- or ----- button for two seconds will scan the FM band. It will automatically stop when it detects a strong signal from a radio station. Press the ----- or ----- button to start the scan again. Or, if you prefer, you can press the ----- or ----- button, one press at a time to seek out the radio station that you want. Push the ----- set volume control mode and adjust the volume with ----- and -----. Push to transmit the FM Mono or Stereo for two seconds.

16