IBM 243X Charging the Battery Pack, Installing the Battery Pack, To charge the battery pack

Learning About the Terminal 1

Charging the Battery Pack

You must fully charge the battery pack before you can use the terminal.

To charge the battery pack

•Place the battery pack in an empty slot in the battery charger. The battery pack fully charges in 3 to 4 hours. For help, see the documentation that came with your charger.

•Install the battery pack in the terminal. For help, see the next section, “Installing the Battery Pack.” Connect one end of the AC power supply adapter cable to the AC power supply, and connect the other end of the AC power supply adapter cable to the power port on the 243X. The battery pack is fully charged in about 3 to 4 hours.

You can also use the powered vehicle dock (Part No. 071695) (sold and ordered separately) connected to an external power supply to charge the battery. For help, see the Trakker Antares 243X Vehicle Dock Installation Instructions (Part No. 071793).

Warning

Replace the battery pack with Part No. 068537 only. The use of any other battery pack may present a risk of fire or explosion.

Avertissement

Remplacez le bloc-batterie par la pièce réf. n° 068537 seulement. L’utilisation de tout autre bloc-batterie présente un risque d’incendie ou d’explosion.

Contact your local Intermec sales representative for a replacement battery pack.

DISPOSE OF USED BATTERY PACKS PROMPTLY. KEEP THEM AWAY FROM CHILDREN.

Installing the Battery Pack

Note: Do not press Fwhen there is no battery pack installed in the terminal.

To install the battery pack

1.The 243X ships with the handstrap installed. Before you install the battery pack, you must remove the handstrap. Rotate the handstrap hook 90 degrees, and unhook it from the 243X.

Handstrap hook

243XU011.eps

1-9