4.Remove the metal shield from the drive bay by inserting a
5.Make sure the drive that you are installing is set correctly as either a master or a slave device.
Note: A serial ATA hard disk drive does not need to be set as either a master or a slave device.
vIf it is the first CD drive or DVD drive, set it as a master device.
vIf it is an additional CD drive or DVD drive, set it as a slave device.
vIf it is an additional parallel ATA hard disk drive, set it as a slave device.
Refer to the documentation that comes with your drive for master/slave jumper information.
6.You might have to remove the bezel to install some drives. Remove the front bezel by pushing in on the blue plastic tab at the rear of the computer.
