IBM 8189, 8128, 8185, 8186, 8187, 8188, 8190 manual Types 8196 and 8197

3.Remove the bay panel from the drive bay by inserting a flat-blade screwdriver at the end and gently prying it loose.

4.Remove the metal shield from the drive bay by inserting a flat-blade screwdriver into one of the slots and gently prying it loose.

5.Make sure the drive that you are installing is set correctly as either a master or a slave device.

Note: A serial ATA hard disk drive does not need to be set as either a master or a slave device.

vIf it is the first CD drive or DVD drive, set it as a master device.

vIf it is an additional CD drive or DVD drive, set it as a slave device.

vIf it is an additional parallel ATA hard disk drive, set it as a slave device.

Refer to the documentation that comes with your drive for master/slave jumper information.

Chapter 3. Types 8196 and 8197 63