USER RESPONSIBLE FOR VERIFYING VERSION AND COMPLETENESS
OEM FUNCTIONAL SPECIFICATION ULTRASTAR XP (DFHC) SSA MODELS 1.12/2.25 GB -1.0" HIGH
8.0 Standards

8.1 Safety

UNDERWRITERS LABORATORY (UL) APPROVAL:
The product is approved as a Recognized Component foruse in Information Technology Equipment
according to UL 1950 (without any Code 3 deviations). The U L Recognized Component marking is
located on the product.
CANADIAN STANDARDS ASSOCIATION (CSA) APPROVAL:
The product is certified to CAN/CSA-C22.2 No. 950-M89 (without any D3 deviations). Th e CSA
certification mark is located on the product.
INTERNATIONAL ELECTROTECHNICAL COMMISSION (IEC) STANDARDS
The product is certified to comply to EN60950 (IEC 950with European additions) by TUV Rheinland.
The TUV Rheinland Bauart mark is located on the product.
SAFE HANDLING:
The product is conditioned for safe handling in regards to sharp edges an d corners.
ENVIRONMENT:
IBM will not knowingly or intentionally ship any units which during normal intended use or foreseeable
misuse, would expose the user to toxic, carcinogenic, or otherwise hazardous substances at levels above
the limitations identified in the current publications of the organizations listed below.
International Agency for Research on Cancer (IARC)
National Toxicology Program (NTP)
Occupational Safety and Health Administration (OSHA)
American Conference of Governmental Industrial Hygienists (ACGIH)
California Governor's List of Chemical Restricted under California Safe Drinking Water and Toxic
Enforcement Act 1986 (also known as California Proposition 65)
SECONDARY CIRCUIT PROTECTION REQUIRED IN USING SYSTEMS
IBM has exercised care not to use any unprotected components or constructions that are particularly
likely to cause fire. However, adequate secondary overcurrent protection isthe responsibility of the user
of the product. Additional protection against the possibility of sustained combustion duet o circuit or
component failure may need to be implemented by the user with circuitry external t o the product. Over-
current limit to the drive of 10 Amps or less should provide sufficient protection.

8.2 Electromagnetic Compatibility (EMC)

FCC Requirements
Pertaining to the disk drive, IB M will provide technical support to assist users in complying with the
United States Federal Communications Commission (FCC) Rules and Regulations, Part 15, Subpart J
Computing Devices “Class A and B Limits”. Tests for conformance to this requirement are performed
with the disk drive mounted in the using system.
VDE Requirements
Source filename=STANDARD IBM Corporation Page 85 of 87