Troubleshooting

If you do not find your problem here, refer toAccess IBM, your on-board help

system. Open Access IBM by pressing theAccess IBM button. The following

section only describes problems that might prevent you from accessing this

help system.

Error messages

Notes:

1. In the charts, x can be any character.

2. The version of PC-Doctor referred to here is PC-Doctor for Windows.

Message Solution
0175: Bad CRC1, stop
POST task
The EEPROM checksum is not correct (block #6). Have the computer
serviced.
0177: Bad SVP data, stop
POST task.
The EEPROM checksum of the supervisor password is not correct. Have the
computer serviced.
0182: Bad CRC2. Enter
BIOS Setup and load
Setup defaults.
The EEPROM checksum CRC2 is not correct. Enter BIOS setup and load
default setting.
0185: Bad startup
sequence settings. Enter
BIOS Setup and load
Setup defaults.
The EEPROM checksum of the startup sequence is not correct. Enter BIOS
setup and load default setting.
0187: EAIAdata access
error
The access to EEPROM is failed. Have the computer serviced.
0188: Invalid RFID
Serialization Information
Area.
The EEPROM checksum is not correct (block # 0 and 1). The system board
should be replaced, and the box serial number needs to be reinstalled. Have
the computer serviced.
0189: Invalid RFID
configuration
information area
The EEPROM checksum is not correct (block # 4 and 5). The system board
should be replaced, and the UUID needs to be reinstalled. Have the
computer serviced.
0190: Critical low-battery
error
The computer turned off because the battery is low.Connect the ac adapter
to the computer and charge the battery,or replace the battery with a fully
charged one.
0191: System Security -
Invalid remote change
requested.
The system configuration change has failed. Confirm the operation and try
again.Toclear the error, enter the IBM BIOS Setup Utility.
0199: System Security -
IBM Security password
retry count exceeded.
This message is displayed if you enter a wrong supervisor password more
than three times. Confirm the supervisor password and try again. Toclear
the error,enter the IBM BIOS Setup Utility.
Solving computer problems
Chapter2. Solving computer problems 11