Video standard (video sources only)
When Video is set to Auto, the projector attempts to pick the video standard
(NTSC, NTSC 4.43, PAL, or SECAM) automatically based on the input signal
it receives. (The video standard options may vary depending on your region
of the world.) If the projector is unable to detect the correct standard, the
colors might not display correctly or the image might appear distorted. If this
happens, manually select a video standard.
Highlight Video standard, press Menu/Select, use the up or down arrows to
cycle through the options, then press Menu/Select to select.
Control menu
To access the Control menu settings, press the Menu/Select button to display
the Main menu, press the down arrow to highlight Control; then press
Menu/Select again to access the Control menu.
Auto source
When Auto Source is On, the projector automatically finds the active source,
checking the default source first. When this feature is Off, the projector
defaults to the source selected in Default Source. To display another source,
you must manually select one by pressing the Source button on the keypad or
the Data or Video button on the remote.
Highlight Auto source, press Menu/Select,then press the up or down arrow
buttons to turn this feature off and on.
Default source
This determines which source the projector checks first for active video when
you turn it on. Select Data-Analog, Data-Digital, composite video, or S-Video.
Highlight Default source; then press Menu/Select. Use the up or down
arrows to cycle through the options; then press Menu/Select to select.
Chapter2. Using the projector 23