6. Grasp the pull tab 1to pull the lamp module out. Dispose of the lamp
module in an environmentally proper manner.
WARNING:
Do not drop the lamp module or touch the glass bulb. The glass
may shatter and cause injury.
7. Install the new lamp module.
8. Tighten the screw on the outside of the module.
9. Press the yellow tab to reconnect the lamp module.
10. Replace the lamp access grill by lining up the ribs on the grill with the
marks on the bottom case and sliding the grill in the direction of the
arrows on the bottom case.
11. Plug in the power cord and press the Power switch to turn the projector
back on.
12. To reset the lamp hour counter in the Status menu, press and hold the
reset button, then press the menu/select button (while still holding down
the reset button) for 10 seconds. Verify that the counter was reset by
pressing the menu/select button and viewing the counter in the Status
menu. See “Status menu”on page 25 for details.
AppendixB. Maintenance and troubleshooting 33