Commands Quick Reference
70
Port Monitoring
set-mon-port Sets the monitoring port on which the sniffer is connected.
monitor Sets the port to be monitored and also starts the monitoring process.
stop-mon Ends port monitoring.
get-nv-mon Retrieves port monitoring information stored in NVRAM.
save-mon Saves current port monitoring information into NVRAM.
clear-nv-mon Clears port monitoring information in NVRAM.
Port Configuration Commands
get-port-cfg Displays the configuration of all ports.
set-port-cfg Sets the port speed, port duplex, or auto.d: auto, 100, 10, or 1000
set-port-state Enables or disables a port when Spanning Tree algorithm is not
running.
get- fctrl Displays the status of the port flow control function..
set- fctrl Sets the mode of operation of the port flow control function..
set-priority-port-cfg sets the priority of a port
get-priority-port-cfg displays the port priority configuration
get-tag-outbound-mode Shows the VLAN Tagging ports’ state.
set-tag-outbound-mode Enables or disables VLAN tagging to a port and should be set to ports
on a network on which all nodes support the IEEE 802.1q. Disable
any port connected to a network on which there are any nodes that do
not support the IEEE 802.1q.
Switching Statistics Commands
clr-cnt Clears switch Ethernet and bridging counters
get-eth-cnt Gets Ethernet counters per port
get-colls-cnt Gets collision distribution counters per port
get-rmon-cnt Gets Ethernet RMON counters per port
get-sdist-cnt Gets packet size distribution counters per port
get-mgm-brcnt Gets switching counters of the mgmt port