vInformation about uploading electronic journal data while the printer is emulating
a Model 4 printer has been added. See AppendixE, “Uploading electronic journal
data,” on page 187.
vThe following commands have been added:
Note: These commands are not supported for Models TI1 and TI2. Currently
installed Model TI3, TG3, TI4, and TG4 printers support these commands
after you download the latest firmware.
– “Proportional font” on page 120
– “Select color printing” on page 137
–n=09 (Align Column Right) for “Align positions” on page 139
– “Enable or disable upside-down printing” on page 144
– “Select character size for scalable fonts” on page 145
– “Fix font matrix” on page 146
– “Print logo inline” on page 146
– “Select thermal paper” on page 147
–n=09 (Code 128A, 128B, and 128C) for “Print bar code” on page 147
vThe following command, which is supported only on Models TF6 and TM6, has
been added:
– “Enable or disable the beeper (Models TF6 and TM6 only)” on page 143
GA27-4151-03
This edition includes information for the support of a USB logic card.
Information that was added includes:
v“USB connector pin assignments” on page 92.
vUSB information has been added to “Voltage conversion circuitry” on page 89.
vThe part number for the available USB cables has been added to “Features used
with the SureMark printers” on page 6.
vInformation about your responsibilities when using USB communications has
been added to “Planning information” on page 9.
vThe data rate for USB communications has been added to “Communication
interfaces” on page 10.
vUSB information has been added to “Hardware requirements” on page 13.
vInformation about installing the SureMark printer for use with USB
communications has been added to “Installing SureMark for USB communication”
on page 21.
vInformation about installing fillers for the SureMark printer when the USB feature
is used has been added to “Installing fillers for USB printers” on page 26.
vCommunication mode information for USB has been added to “USB
communication mode” on page 31.
vRelevant information for performing problem determination with USB has been
added to Table3 on page 67.
Updated April 2, 2009
Summary of changes xix