IBM TF6, TG3, TG4, TG8, TG9, TI1, TI2, TI3, TI4, TI8, TI9, TM6 Impact code page

bytes that define the character. If, as in this case, the character is defined

before all 64 bytes have been used, the rest of the bytes are filled with X'0'

(see Figure 50).

Note: If wb were set to 03, then the total number of data bytes would be

98 (3×32+2)

Impact code page

Youdefine the character matrix for each code page with MCT #4 for impact code

page 1 and MCT #5 for impact code page 2. See Table17 on page 125.

If the matrix defines the characters as 9 dots high or less, a print line will be printed

in one pass of the print head. When the matrix is defined as greater than 9 dots

high, it takes two passes of the print head per print line.

Landscape printing is limited to characters with a height of 9 dots or less. If

user-defined characters are to be used in landscape print mode, they must be less

than 10 dots high.

The number of data bytes per character loaded is 2 × character width. The total

number of data bytes for this command is 2 × character width × (1+m−n). Each

slice is defined with two bytes; the most significant bit (MSB) of each slice is the

bottom of the character.

0000111100000000

0001111110000000

0011111111000000

0111000011100000

0110000001100000

1100000000110000

1111111111110000

1100000000110000

0000000000000000

0F00

1F80

3FC0

70E0

6060

C030

FFF0

C030

0000

row #

Figure50. Proportional font example

Updated April 2, 2009

122 SureMark Printers User’s Guide

IBM Impact code page

Models: TF6 TG3 TG4 TG8 TG9 TI1 TI2 TI3 TI4 TI8 TI9 TM6

bytes that define the character. If, as in this case, the character is defined

before all 64 bytes have been used, the rest of the bytes are filled with X'0'

(see Figure 50).

Note: If wb were set to 03, then the total number of data bytes would be

98 (3×32+2)

Youdefine the character matrix for each code page with MCT #4 for impact code

page 1 and MCT #5 for impact code page 2. See Table17 on page 125.

If the matrix defines the characters as 9 dots high or less, a print line will be printed

in one pass of the print head. When the matrix is defined as greater than 9 dots

high, it takes two passes of the print head per print line.

Landscape printing is limited to characters with a height of 9 dots or less. If

user-defined characters are to be used in landscape print mode, they must be less

than 10 dots high.

The number of data bytes per character loaded is 2 × character width. The total

number of data bytes for this command is 2 × character width × (1+m−n). Each

slice is defined with two bytes; the most significant bit (MSB) of each slice is the

bottom of the character.