|
|
|
|
| 8 |
|
| TROUBLESHOOTING | |||
If your transceiver seems to be malfunctioning, please check |
|
|
|
| |
the following points before sending it to a service center. |
|
|
|
| |
|
|
|
|
| |
PROBLEM | POSSIBLE CAUSE |
| SOLUTION | REF. | |
|
|
|
|
| |
No power comes ON. | • The battery is exhausted. |
| • Recharge the battery pack. | p. 12 | |
| • Bad connection to the battery pack. |
| • Check the connection to the transceiver. | — | |
|
|
|
|
| |
No sound comes from | • Volume level is too low. |
| • Set [VOL] to a suitable level. | p. 5 | |
the speaker. | • Tone squelch is activated. |
| • Turn the tone squelch OFF. | p. 11 | |
|
|
|
|
| |
Transmitting is impossi- | • The battery is exhausted. |
| • Recharge the battery pack. | p. 12 | |
ble. |
|
|
|
|
|
|
|
|
|
| |
No contact possible with | • The transceiver is set to |
| • Push [DUP] to set to simplex. | p. 7 | |
another station. | • The other station is using tone squelch. |
| • Turn ON the tone squelch function. | p. 11 | |
|
|
|
|
| |
The displayed channel | • Lock function is activated. |
| • Push [DUP] for 1 sec. to cancel the func- | p. 7 | |
cannot be changed. |
|
| tion. |
| |
|
|
|
|
| |
Scan does not start. | • The monitor function is activated. |
| • Push | p. 6 | |
| • Scan tag is not programmed. |
| • Set scan tag to desired channels. | p. 9 | |
|
|
|
|
| |
No beep sounds. | • Beep tones are turned OFF. |
| • Turn beep tones ON in SET mode. | p. 15 | |
|
|
|
|
|
|
17
