Icom IC-M2A Battery Case Release Screw To remove the battery case, To attach the battery case

ïBATTERY CASE RELEASE SCREW To remove the battery case:

Turn the screw counterclockwise, then pull the battery pack in the direction of the arrow as shown below.

To attach the battery case:

Insert the battery case in the IC-M2A completely, then turn the screw clockwise.

NOTE: When removing or attaching the battery case, use a coin or flat-head screwdriver to loosen or tighten the bottom screw.

Screw position

when removing battery

LOCK

OPEN

Screw position

when attaching battery

LOCK

OPEN

PANEL DESCRIPTION 2

CAUTION!:

When attaching or releasing a battery pack, make sure the rubber seal is set in the groove of the battery pack/case correctly. If the seal is not neatly in the groove it may be damaged when attaching the battery pack/case.

If the seal is damaged, waterproofing is not guaranteed.

NOTE:

When attaching a battery pack/case, make sure dust etc. does not adhere to the rubber seal. If dust etc. is on the seal when attaching a battery pack/case, the water resistant may be reduced.

Make sure both the rubber seal (purple) is set to the groove correctly and dust etc. does not adhere to it.

Correct position	Incorrect position
	Rubber seal
	Groove
Battery pack/case	Battery pack/case

3