COMMANDMIC II™
e ATTENUATOR/INTERCOM/SCRAMBLER KEY [LO/DX• IC
➥Push to toggle the Attenuator function ON or OFF. (p. 45)
• “LOCAL” appears when the Attenuator function is turned ON.
➥Push for 1 sec. to activate the Intercom function. (p. 50)
➥Calls the
NOTE: Voice scrambler is not available for the IC- M422.
r
➥Push to select and toggle the regular channels and weather channels. (p. 44)
➥While pushing [H/L], push to select one of three chan- nel groups in sequence. (p. 44)
• U.S.A., International and Canadian channels are available.
➥Push for 1 sec. to start Dualwatch or
➥Push to stop Dualwatch or
t CHANNEL 16/CALL CHANNEL KEY [16•9]
➥Push to select Channel 16. (p. 44)
➥Push for 1 sec. to select call channel. (p. 44)
• “CALL” appears when call channel is selected.
➥Push for 3 sec. to enter call channel programming con- dition when call channel is selected. (p. 46)
➥While pushing [CH/WX• DW U/I/C], push to enter the channel comment programming condition. (p. 51)
➥While turning power ON, push to enter Set mode. (p. 49)
yCHANNEL UP/DOWN KEYS [Y]/[Z]
➥Push to select the operating channel, Set mode set- tings, etc. (pgs. 44, 49)
➥Push and hold [Y] to move upward through the operat- ing channels continuously.
➥Push and hold [Z] to move downward through the op- erating channels continuously.
➥Push [Y] or [Z] to adjust audio level or noise squelch level after pushing [VOL• DIM PA/RX 
] or [SQL• MONI L], respectively. (p. 45)
➥Push [Y] or [Z] to adjust the brightness of the LCD and
key backlight after pushing [VOL• DIM PA/RX ] for 1 | 12 |
sec. (p. 47) |
|
➥Checks TAG channels or changes scanning direction during scan. (p. 48)
➥Push [Y] or [Z] to adjust the audio level during in Pub- lic Address mode. (p. 50)
➥While pushing [VOL• DIM PA/RX 
], push [Y] or [Z] to adjust the audio level during in RX Speaker mode. (p. 50)
u PTT SWITCH [PTT] (p. 45)
Push and hold to transmit; release to receive.
41