■Set mode programming

Set mode is used to change the condition of the transceiver’s functions and the microphone’s own functions:

Transceiver’s functions—

Scan type, Scan resume timer, Weather alert, Dual/Tri-watch, Beep tone*1, LCD backlight*1, LCD contrast*1 and Radio PWR.

Microphone’s own functions—

Beep tone*2, LCD backlight*2 and LCD contrast*2

*1 For transceiver setting *2 For microphone setting

In this section, instructions are for the microphone’s own functions only. Refer to pgs. 32 to 34 for the setting of the other functions. (Some functions cannot be selected from the HM-157.)

DEntering Set mode

qTurn power OFF.

wWhile pushing [16•9], turn power ON.

•After a beep emission, a Set mode item appears at the channel comment indicator.

eAfter the display appears, release [16•9].

rPush [16•9] to select the desired item, if necessary.

tPush [Y] or [Z] to select the desired condition of the item. y Turn power OFF, then ON again to exit Set mode.

COMMANDMIC II™ HM-157 12

•Beep tone

You can select the silent operation by turning beep tones OFF or you can have confirmation beeps sound at the push of a key by turning beep tones ON.

•LCD backlight

The LCD backlight brightness can be adjusted from OFF, 1 (dark) to 7 (bright.)

•“ ” scrolls at the channel

comment indicator.

 

Scrolls

• LCD contrast

12

The LCD contrast can be adjustable in 4 levels. 1 is the lowest contrast, and 4 is the highest con- trast.

• “ ” scrolls at the channel comment indicator.

Scrolls

49