Manuals / Brands / Home Audio / Stereo Receiver / Icom / Home Audio / Stereo Receiver

Icom IC PCR100 Changing the automatic sweep step limit

1 44

Download 44 pages, 402.02 Kb

35

6

BAND SCOPE

tClick the waveform to select the frequency of the signal.

•Click the [s/❙❙] button to pause a sweep and monitor the fre-

quency. Repeat to resume the sweep.

•While pausing the band scope, y ou can also select the frequency

by clicking the waveform. The current receive frequency is

marked by a dotted line and the previous receive frequency is

displayed at center.

yClick the close (["]) b utton to stop sw eeping and close the

band scope screen.

■Changing the automatic

sweep step limit

The frequency steps used while sweeping are automatically

set according to the tuning step. How ev er, these steps can be

deﬁned using the [BAND SCOPE] tab on the setting screen.

qCall up the setting screen if it is not displayed.

•For the multi-function receiver screen, click the [SET] button.

•For the simple function receiver screen, click the [MENU] button

and select the ‘Function Setting (SET).’When the scan controller

screen is in use, click the [SET] button on the screen.

wClick the [BAND SCOPE] tab.

eClick a frequency step range from inside the [Automatic

Sweep-Step Limit].

•The sw eep step range can be selected from one of 1 kHz to 100

kHz, 1 kHz to 50 kHz or 1 kHz to 25 kHz.

rClick the close (["]) button to close the setting screen.

DAbout the limit indicator

When using the band scope function and the selected tuning

step (TS) is outside the automatic s w eep step setting, [LIMIT]

appears in the band scope displa y. This indicates that the tun -

ing step (TS) and the sweep step width are not the same.

Contents

Main IMPORTANT READ ALL INSTRUCTIONS SA VE THIS INSTR UCTION MANU AL USE SYSTEM REQUIREMENTS CAUTIONS RWARNING! NEVER connect the receiver to an AC NEVER NEVER DO NO T A V OID TABLE OF CONTENTS INSTALLATION Hardware installation 1 Antenna installation CA UTION: Grounding RWARNING: NEVER use a gas pipe or electrical AF output level selection CA UTION: DMulti-function receiver screen DSimple function receiver screen 1 Software installation DInstallation DSoftware update information RS-232C port setting DMulti-function receiver screen DSimple function receiver screen Mouse property setting DSetting the button conguration 2 Page Page Page Function display Page Simple function receiver screen Page Function controller screen Simple function receiver sub screens 3 Receiving Setting a frequency DUsing the tuning dial DUsing the keypad DUsing the PC keyboard 3 Setting a tuning step Receive mode selection Automatic mode selection DSetting the automatic mode function 3 Setting squelch level IF lter selection Attenuator function Automatic noise limiter 4 General DMemory channel contents Saving memory channels Selecting a memory channel DUsing the up/down button on the multi- function receiver screen DUsing the [Mch] button on the multi- function receiver screen DUsing the memory list screen 4 Clearing a Memory channel programming DUsing the memory list screen memory channel Editing the memory list DEditing a bank name DInserting and deleting channels 5 Scan types Programmed scan Setting scan edges Auto memory write scan Memory scan Versatile memory scan Scan resume condition Scan speed setting 6 Operation BAND SCOPE Changing the automatic sweep step limit DAbout the limit indicator 7 37 TROUBLESHOOTING PROBLEM POSSIBLE CA USE SOLUTION REF. 9 Specications Supplied accessories qw er SPECIFICATIONS AND SUPPLIED ACCESSORIES