34
6BAND SCOPE
■Operation
The band scope function allows you to visually chec k a spec-
ified frequency range.
Receive audio is muted while monitor ing the band scope.
Push [s/❙❙] to pause sweeping and receive the audio.
DUsing the multi-function receiver screen
qClick the sweep start/pause button ([s/❙❙]) to begin a
s weep; signal conditions appear starting from the center of
the range.
•Conditions over the entire set frequency span can be obser ved
around the center frequency of the currently received frequency.
wClick the [SPAN+] or [SPAN–] button to select the sweep
width through SPAN1 (±100 kHz) to SPAN4 (±2 MHz).
eClick the [TSJ] or [TSK] button to select the s w eep tuning
step.
•“LIMIT”appears when a tuning step greater than the sweep step
range is selected.
rClick the waveform to select the frequency of the signal.
•Click the [s/❙❙] button to pause a sweep and monitor the fre-
quency. Repeat to resume the sweep.
•While pausing the band scope, y ou can also select the frequency
by clicking the waveform. The current receive frequency is
marked by a dotted line and the previous receive frequency is
displayed at center.
tClick the sweep stop button ([‘]) to cancel a sweep.
DUsing the simple function receiver screen
qCall up the band scope screen if it is not displayed.
•Click the [MENU] button and select the ‘Band Scope.’
wClick the sweep start/pause button ([s/❙❙]) to begin a
s weep; signal conditions appear starting from the center of
the range.
•Conditions over the entire set frequency span can be obser ved
around the center frequency of the currently received frequency.
eClick the [∫] or [√] button to select the sweep width
through SPAN1 (±100 kHz) to SPAN4 (±2 MHz).
•Choose [SPAN1] when band conditions are crowded (many sig-
nals are present); choose [SPAN4] when few signals are present.
rClick the [TSJ] or [TSK] button on the function controller
screen to select the sweep tuning step.
•Click [MENU] and select the ‘Function controller’when it is not
displayed.
•“LIMIT”appears when a tuning step greater than the sweep step
range is selected.
Click to select sweep width.
Click to start or pause sweeping.