10 TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | SOLUTION | REF. |
No power comes ON. | • Bad connection to the power supply. | • Check the connection to the transceiver. | p. 35 |
|
|
|
|
No sound comes from | • Squelch level is too deep. | • Set squelch to the threshold point. | p. 8 |
the speaker. | • Volume level is too low. | • Set [VOL] to a suitable level. | p. 8 |
| • Speaker has been exposed to water. | • Drain water from the speaker. | — |
| • Internal speaker is turned OFF. | • Turn the internal speaker ON in set mode. | p. 32 |
|
|
|
|
Sensitivity is low. | • The attenuator is activated. | • Push [LO/DX] to turn the function OFF. | p. 8 |
|
|
|
|
Transmitting is impossi- | • Some channels are for low power or re- | • Change channels. | pgs. |
ble, or high power can- | ceive only. |
| 6, 41 |
not be selected. | • The output power is set to low. | • Push [HI/LO] to select high power. | p. 8 |
|
|
|
|
Scan does not start. | • “TAG” channel is not programmed. | • Set the desired channels as “TAG” chan- | p. 13 |
|
| nels. |
|
|
|
|
|
No beep sounds. | • Beep tone is turned OFF. | • Turn the beep tone ON in set mode. | p. 32 |
| • The squelch is open. | • Set squelch to the threshold point. | p. 8 |
|
|
|
|
Receive signal cannot | • Optional voice scrambler is turned OFF. | • Turn the optional voice scrambler ON. | p. 10 |
be understood. | • Scramble code is not set correctly. | • Reset the scramble code. | p. 33 |
|
|
|
|
Distress call cannot be | • MMSI (DSC self ID) code is not pro- | • Program the MMSI (DSC self ID) code. | p. 14 |
transmitted. | grammed. |
|
|
|
|
|
|
40
