Locate the Reed Switch (24) and the Magnet (18) on |
| |
the left side of the Pulley (120). Turn the Pulley until |
| |
the Magnet is aligned with the Reed Switch. | Make | |
sure that the gap between the Magnet and the |
| |
Reed Switch is about 1/8”. | If necessary, loosen the | |
Screw (25) and move the Reed Switch slightly. Retighten the Screw. Reattach the Hood, and run the treadmill for a few minutes to check for a correct speed reading.
1/8”
25
24
Top
View
120
18
PROBLEM: The walking belt slows when walked on |
|
|
|
| |
SOLUTION: | a. Use only a |
| |||
| b. If the walking belt is overtightened, treadmill perfor- |
| b | ||
| mance may decrease and the walking belt may be |
| |||
| permanently damaged. Remove the key and | UN- |
|
| |
| PLUG THE POWER CORD | . Using the included allen |
|
| |
| wrench, turn both rear roller adjustment bolts counter- |
|
|
| |
| clockwise 1/4 of a turn. When the walking belt is prop- |
|
|
| |
| erly tightened, you should be able to lift | the edges | of |
| |
| the walking belt 3 to 4 inches off the walking platform. |
|
|
| |
| Be careful to keep the walking belt centered. Plug in |
| Rear Roller Adjustment Bolts |
| |
| the power cord, insert the key and run the treadmill |
|
| ||
|
|
|
| ||
| for a few minutes. Repeat until the walking belt is |
|
|
| |
| properly tightened. |
|
|
|
|
PROBLEM: The walking belt is |
| |||
SOLUTION: | a. If the walking belt is |
| ||
| and UNPLUG THE POWER CORD | . If the walking | ||
| belt has shifted to the left, | use the allen wrench to |
| |
| turn the left rear roller bolt clockwise 1/2 of a turn; | if | ||
| the walking belt has shifted to the right, | turn the | ||
| bolt counterclockwise 1/2 of a turn. Be careful not to |
| ||
| overtighten the walking belt. Plug in the power cord, |
| ||
| insert the key and run the treadmill for a few minutes. |
| ||
| Repeat until the walking belt is centered. |
|
| |
| b. If the walking belt slips when walked on, first remove |
| ||
| the key and | UNPLUG THE POWER CORD | . Using | |
| the allen wrench, turn both rear roller bolts clockwise |
| ||
| 1/4 of a turn. When the walking belt is correctly tight- |
| ||
| ened, you should be able to lift each side of the walk- |
| ||
| ing belt 3 to 4 inches off the walking platform. Be |
| ||
| careful to keep the walking belt centered. Plug in the |
| ||
| power cord, insert the key, and walk on the treadmill |
| ||
| for a few minutes. Repeat until the walking belt is |
| ||
| properly tightened. |
|
| |
a
b
23
