5.Open part bag A. Hold the Pulse Bar (125) near the Console Base (85). Connect the Pulse Wire (124) on the Pulse Bar to the indicated wire on the Console Base.

The connectors should slide together easily and

snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try to connect them again. Insert the wires into the hole in the

Console Base.

Have a second person hold the Pulse Bar (125) firmly on

 

the Console Base (85). Attach the Pulse Bar to the

 

Console Base with two

1 1/4” Screws (92) in the loca-

tions shown. Be careful not to damage the Pulse

 

Wire (124) or the wire on the Console Base.

Next,

tighten two 2” Silver Screws (93) into the Console Base

 

and the Pulse Bar in the locations shown.

Note: The

correct Screws must be used in the correct loca-

 

tions, or the Pulse Bar may be damaged.

 

6.Identify the Left and Right Handrails (68, 81) (see the end views of the Handrails in the inset drawing). The

curved edges of the Handrails should be on the outside.

Slide the Right Handrail (81) onto the Right Handrail Bracket (113), and press the lip on the front of the Right Handrail under the Console Base (85). (Note: It may be helpful to tip the Right Handrail and to tap it with a rub-

ber mallet to correctly position it.) Tighten three 3/4” Screws (6) into the Right Handrail as shown. Note: It may be necessary to move the lower end of the Right Handrail slightly to align the lower screw hole.

Attach the Left Handrail (68) in the same way.

See assembly step 1. Tighten the four 1 1/4” Bolts (104).

7.Press the Latch Knob Sleeve (75) into the Left Upright (69). Note: It may be helpful to use a rubber mallet to fully insert the Latch Knob Sleeve.

Remove the Latch Knob (70) from the Latch Pin (80).

Make sure that the Latch Pin Collar (76) and the Spring

(77)are on the Latch Pin. (Note: If there are two Latch Pin Collars, place one on each side of the Spring.) Insert the Latch Pin into the Left Upright (69) and tighten the Latch Knob onto the Latch Pin.

5

 

 

 

93

 

92

125

 

 

 

 

124

 

124

93

85

 

 

 

 

92

6

 

 

68

 

 

6

 

 

 

Lip

85

Curved Edge

81

 

 

 

 

 

113

 

 

6

(81) (68)

 

 

7

 

 

70

 

 

 

77

 

75

76

 

 

 

 

80

 

69

 

 

8

Page 8
Image 8
Image IMTL41530 Connectors should slide together easily, Console Base with two, Next, Pulse Bar in the locations shown