Image IMTL41530 user manual Assembly

ASSEMBLY

Assembly requires two persons.Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is

coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver
wire cutters	, rubber mallet	, and adjustable wrench	.

For help identifying the assembly hardware, refer to the drawings below. Note: The assembly hardware and other

small parts are packaged in separate part bags.Do not open the part bags until instructed to do so. (The part bags are not labeled according to the order in which they are to be opened.) If a part is not found in

the part bags, check to see if the part has been preassembled.

3/4” Screw (6)–20	1	1/4” Screw (92)–2	2”	Silver Screw (93)–2
1 1/4” Bolt (104)–4			Wheel Bolt	(107)–2
1” Bolt (71)–2		Wheel Nut (21)–2		Internal Star
				Washer (72)–6

1. Open part bag B.	Identify the Right Upright (82) (the		1
Left Upright [69] has a large round hole in the location
shown). Lay the Right Upright flat. Cut the plastic ties off				83
the lower end of the Right Upright. Next, feed the Wire				82
Harness (83) into the bottom of the Right Upright and
pull it out of the hole in the top. Note: There may be a tie				69
on the end of the Wire Harness to help you pull it
through the hole.
Attach the Right Upright (82) to the bracket on the right				Bracket
side of the Base (109) with two 1 1/4” Bolts (104) and
two Internal Star Washers (72). (Note: It may be helpful			Hole	72
to use a rubber mallet to fully insert the Right Upright
				104
into the bracket.)	Do not tighten the Bolts yet. Be
careful not to damage the Wire Harness.
Attach the Left Upright (69) to the left side of the				109
Base (109) in the same way.		Note: There is not a wire
harness on the left side.

6