InFocus LP 735, LP 725 warranty Usage Guidelines, If You Need Assistance, Warranty

Usage Guidelines

•Do not look directly into the projection lens when the projector is turned on. The bright light may harm your eyes.

•Do not block the grills on the projector. Do not place the projec- tor on cloth table coverings, as they may get sucked up to the vents. Restricting the air flow can cause it to overheat and turn off.

•Handle the projector as you would any product with glass components. Be especially careful not to drop it.

•Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.

•This projector is not intended for use in a mainframe computer room as defined in the Standard for the Protection of Electronic Computer/Data Processing Equipment, ANSI/NFPA 75.

•Transport the projector in a vendor-approved hard or soft case. Part numbers for these cases are listed on page 52. Call your In Focus dealer to order.

If You Need Assistance

The first place to look for help is in this manual. Be sure to check the guidelines in “Troubleshooting” on page 44.

If this manual doesn’t answer your question, call your In Focus dealer. You can also call In Focus Customer Service directly at 1-800-799-9911. Customer Service is free between 5 a.m. and

5 p.m. PST, Monday through Friday. Service is available in North America after hours and on weekends for a fee at 1-888-592-6800. In Europe, call In Focus in The Netherlands at

(31)23-5540310. In Singapore, call (65) 740-6435. Or, send us an e-mail at techsupport@infocus.com

Our World Wide Web address is http://www.infocus.com.

Warranty

This product is backed by a limited one-year warranty. The details of the warranty are printed at the back of this manual. Longer term warranties can be purchased from your In Focus dealer. Refer to page 52 for part numbers.

NOTE: If the projector overheats and turns off, you must wait about 30 seconds before you attempt to turn it back on.

5