Replacing the Projection Lamp
The lamp hour counter on the status bar at the top of the menus counts the number of hours the lamp has been in use. After 2000
hours of use, the lamp monitor LED, marked 
on the top of the projector near the keypad, lights. After 2050 hours, the lamp switches off completely and must be replaced. You can order new lamp modules from your In Focus dealer. See “Accessories” on page 51 for information.
Follow these steps to replace the projection lamp:
1Turn off the projector and unplug the power cord.
2Wait 30 minutes to allow it to cool thoroughly.
3Using a small,
4Pull the lamp cover up and remove it.
FIGURE 34
Removing the lamp module door
5Loosen the two
6Remove the module (Figure 35).
WARNING: To avoid burns, allow the projector to cool for at least 30 minutes before you open the lamp module door. Never extract the lamp module while the lamp is operating.
CAUTION: Never operate the projector with the lamp cover open or removed. This disrupts the air flow and causes the projector to overheat.
41
