12Plug in the power cord and turn the projector back on. The lamp monitor light and lamp hour counter in the Status menu are automatically reset.
Replacing the Batteries in the Remote Control
The life of the batteries depends on how often and how long you use the remote. Symptoms of low battery charge include erratic responses when using the remote and a reduced range of opera- tion.
Follow these steps to replace the batteries:
1Turn the remote face down in your hand.
2Slide the battery cover off the end of the remote by pressing on it with the heel of your hand.
3Remove the old batteries.
4Install two new AA alkaline batteries. Make sure you install each in the correct direction.
5Slide the battery cover back on the remote.
Using the Kensington Lock
The projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security System (Figure 27). Refer to the information that came with the Kensington System for instructions on how to use it to secure the projector.
FIGURE 27
Installing the Kensington lock
35
