InFocus LS700 Problem Computer image isn’t centered on the screen, Problem Image is out of focus

If you’re using Windows 95:

1Open “My Computer” icon, the Control Panel folder and then the Display icon.

2Click the Settings tab.

3Verify that the Desktop area is set to 1024x768 or less. Also check the following:

•Does your computer have a compatible graphics port? The pro- jector isn’t CGA or EGA compatible.

•Is your computer’s graphics board turned on? This is espe- cially true for laptop computers.

Problem: Computer image isn’t centered on the screen

•Reposition the image. Refer to “Horizontal Position” on page 26 and “Vertical Position” on page 26.

•If you’re using an extension cable between the CableWizard and the projector, make sure it’s InFocus-approved.

Problem: Image is too wide or narrow for screen

•You might need to manually adjust the tracking to reduce or enlarge the projected image. Refer to “Manual Tracking” on page 25.

•Adjust the resolution of your monitor if it’s greater than 1024x768. Only these resolutions at 75 Hz or less will display on the projector.

Problem: Image is out of focus

•Turn the projection lens to focus the image.

•Make sure the projection screen is at least 4 feet (1.2m) from the projector.

•Make sure the projector is turned off, then check the projection lens to see if it needs cleaning.

39