Using the remote control
The remote uses two (2) AA batteries. They are easily installed by removing the cover from the remote’s back, aligning the + and - ends of the batteries, sliding them into place, and then replacing the cover.
Caution:
•When disposing of the batteries, be sure to do so in an enviromentally proper manner.
•If the remote control gets wet, wipe it dry immediately.
•Avoid excessive heat and humidity.
•Ensure the batteries' polarity
•Do not mix new and old batteries together, or mix different types of batteries together.
•Replace the batteries as soon as they run out.
•Remove batteries from the remote control when storing or not in use for a pro- longed period.
To operate, point the remote at the front of the projector (not at the computer). The range of optimum operation is about 15 feet (4.5m).
Press the remote’s Power button to turn the projector on and off (see page 13 for shutdown info).
Press the remote’s Menu button to open the projector’s menu system. Use the arrow buttons to navigate, and the Select button to select features and adjust values in the menus. See page 26 for more info on the menus.
The remote also has:
•Volume buttons to adjust the sound.
•Custom button that can be assigned to a special function, like Blank Screen or Freeze (see page 29).
•Source button to switch between sources.
•Blank button to blank the screen.
•Presets button to select stored settings (see page 27).
•Mute button to silence the audio.
•Auto Image button to resynch the projector to the source
•Resize button to switch among aspect ratios (see page 27).
•Help button to get help with connecting sources and improving the picture.
Troubleshooting the remote
•Make sure the batteries are installed in the proper orientation and are not dead.
•Make sure you’re pointing the remote at the projector or the screen, not the computer, and are within the remote range of 15 feet (4.5m). For best results, point the remote at the projector.
navigation buttons
21
