Insignia NS-27RTV manual 10

NS-27RTV 27-inch Color TV

•When you make a menu selection, your changes occur immediately. You do not have to press EXIT to see your changes.

•When you are finished programming the menus, press EXIT.

Using the menu

To access the menu using the TV buttons:

Press both of the volume and buttons at the same time. The menu screen appears

To access the menu using the remote control:

Press MENU. The menu screen appears.

To select a setting using the TV buttons:

Use the channel and buttons and volume and buttons.

To select a setting using the remote control:

Use the channel and buttons and volume and buttons.

Setting the language

You can choose from three different languages (English, French, and Spanish) for the on-screen displays.

To select a menu language:

1Press MENU. The menu screen appears.

Note If no buttons are pressed for more than 15 seconds, the menu screen returns to normal television operation automatically.

2Press or to select SETUP menu.

3Press or select LANGUAGE.

4Press or to select the desired language: English (ENGLISH), French (FRANÇAIS), or Spanish (ESPAÑOL).

5Press EXIT to return to the normal screen.

Memorizing channels

This television is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the television’s memory. This television can receive up to 250 VHF/UHF channels and 500 cable television channels.

To use this television with an antenna, set the TV/CABLE menu option to the TV mode. When shipped from the factory, this menu option is in the CABLE mode.

Selecting TV or cable

To select TV or cable input:

1Press MENU. The menu screen appears.

2Press or to select the SETUP menu.

3Press or to select TV/CABLE.

4Press or to select TV or CABLE.

•TV—VHF/UHF channels

•CABLE—Cable television channels

5Press EXIT to return to the normal screen.

Cable chart

The following chart is typical of many cable system channel allocations. The number on the top is the number on the television. The number or letter on the bottom is the corresponding cable channel.

Automatic memory tuning

To automatically memorize channels:

1Press MENU. The menu screen appears.

2Press or to select the SETUP menu, then press or to select AUTO CH MEMORY.

3Press or . The television begins memorizing all of the channels available in your area.

Depending on the reception condition, it may take approximately ten minutes to complete memorizing digital cable channels.

Note Some new channels may be added. You should complete the AUTO CH MEMORY procedure periodically.

Adding and deleting channels

To add or delete channels:

1Press MENU. The menu screen appears.

2Press or to select the SETUP menu, then press or to select ADD/DELETE.

3Press or . The ADD/DELETE menu appears.

4Press or to select ADD/DELETE, then press .

5Select the desired channel to be memorized or deleted using or .

6Press or to select ADD or DELETE.

7Repeat steps 5-6 for other channels you want to add or delete, then press ENTER.

8Press EXIT to return to the normal screen.

Note To return from the ADD/DELETE menu to the SETUP menu, select SETUP MENU,

then press or .

Using clear all

All channels can be deleted from the channel memory.

To clear all channels from memory:

1Press MENU. The menu screen appears.

2Press or to select the SETUP menu.

3Press or to select CLEAR ALL, then press or .

www.insignia-products.com 9