Insignia 46"/55" 1080p LED TV

Connecting an antenna or cable TV (no box)

To connect an antenna or cable TV (no box):

1Make sure that your TV’s power cord is unplugged, and all connected equipment is turned off.

2Connect a coaxial cable to the ANT/CABLE jack on the back of your TV and to the antenna or cable TV wall jack.

Antenna or cable TV (no box)

Connecting a DVD or Blu-ray player

Using HDMI (best)

To connect a DVD or Blu-ray player using HDMI:

1Make sure that your TV’s power cord is unplugged and the DVD or Blu-ray player is turned off.

2Connect an HDMI cable (not provided) to one of the HDMI jacks on the side of your TV and to the HDMI OUT jack on the DVD or Blu-ray player.

DVD or Blu-ray player

Y / VIDEO

PB

PR

L

R

Back of TV

Coaxial cable

HDMI cable

Side of TV

3Plug your TV’s power cord into a power outlet, then turn on your TV.

4Go through the Setup Wizard on page 21.

Notes

Use a coaxial cable to eliminate interference and noise from radio waves.

Do not bundle the coaxial cable with the power cord or other cables.

If the antenna is not installed correctly, contact qualified service personnel to correct the problem.

If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna or use a highly directional outdoor or set-top antenna with a built-in amplifier.

If the picture quality is good on some channels and poor on others, the problem may be caused by a poor or weak signal from the broadcaster or cable TV provider.

If you connect to cable or satellite TV without a set-top box and experience poor picture quality, you may need to install a set-top box to improve signal reception and picture quality. Contact your cable or satellite TV provider about upgrading to a set-top box.

Many high-definition (HD) channels upscale standard-definition (SD) content. The picture displayed on your TV is still displayed as SD, thus the picture quality will not be as clear or crisp as it would be if the content was originally recorded in HD.

3Plug your TV’s power cord into a power outlet, then turn on your TV.

4Turn on the DVD or Blu-ray player, then set it to the correct output mode. For more information, see the documentation that came with the player.

5Press INPUT to open the Input Source list.

6Press S or T to highlight HDMI 1, HDMI 2, HDMI 3, or HDMI 4 then press ENTER.

Note

You can also press HDMI repeatedly to select the DVD or Blu-ray player.

www.insigniaproducts.com

13

Page 17
Image 17
Insignia NS-46E480A13A, NS-55E480A13A manual Connecting an antenna or cable TV no box, Connecting a DVD or Blu-ray player