Insignia
3 Select a preset number between 1 and 30, | 3 Press the PRESET / buttons on the |
then press the MEMORY button. | receiver. |
OR
Notes
•When using the numeric keypad on the remote control, press the number you want. If your number is greater than nine, enter the first digit, then enter the second digit within two seconds.
•The station has been stored in memory. When using the numeric keypad, the station is stored automatically without pressing the MEMORY button.
•A stored frequency is erased from memory by storing another frequency in its place.
•If MEM goes off, start again from step 2.
4Repeat this procedure to memorize additional stations.
Tuning to preset stations
To tune to a preset station:
1Select the tuner as the input source.
2Press T/P MODE to select the preset mode.
OR
OR
Enter the preset number using the numeric keypad.
Notes
When using the numeric keypad on the remote control, press the number you want. If your number is greater than nine, enter the first digit, then enter the second digit within two seconds.
Scanning preset stations in sequence
To scan preset stations:
1Press the PRESETS button on the remote control.
OR
The receiver starts scanning the stations in the preset sequence. Each station is sampled for five seconds.
2Press the PRESETS button again to stop scanning.
PRESETS lights up.
11 |