Insignia
2 Load two type AAA batteries into the | Use the remote control within about 23 feet |
compartment matching the polarity indicated. | (7 meters) of the receiver and within 30 degrees |
| of perpendicular to the front of the receiver. |
3Replace the cover.
Caution
•Do not expose the remote control to shock. In addition, do not expose the remote control to liquids, and do not place in an area with high humidity.
•Do not place the remote control under direct sunlight. The heat may cause deformation of the remote control.
•The remote control may not work properly if the remote sensor window of the receiver is under direct sunlight or strong lighting. In such a case, change the angle of the lighting or receiver, or operate the remote control closer to the remote sensor window.
Note
Remove the batteries if they are not to be used for a long period of time.
Using the remote control
Use the remote control by pointing it towards the receiver’s remote sensor window. Objects between the remote control and sensor window may prevent proper operation.
Using your receiver
Tip
The following settings are stored in memory before the receiver is turned off:
•INPUT SELECTOR settings
•Preset stations.
If the electricity fails or the AC power cord is unplugged for more than two weeks, your memory is cleared.
Listening to a program
To listen to a program:
1 Press the POWER button on the receiver to put the receiver in Standby mode. The STANDBY indicator lights up.
Tip
You can turn the receiver off by pressing the
POWER button on the receiver while it is in
Standby mode.
2Press the POWER ON button on the remote control to turn the receiver on.
23’ (7m)
OR
Tip
You can put the receiver in Standby mode by pressing the STANDBY button on the remote control when the receiver is on.
Tip
With the receiver in Standby mode, you can also turn the power on by pressing an Input Selector button.
7 |