Insignia NS-R2000 Maintaining, Troubleshooting

Insignia NS-R2000 Stereo Receiver

Adjusting the display brightness							Category	Problem		Possible Solution
To adjust the display brightness:
							No sound	1	The speaker	1	Check the
• Press the DIMMER button to specify the									cords are		speaker
	brightness of the display.							2	disconnected.	2	connections.
									The volume is		Adjust the
									adjusted too low.		volume.
								3	The MUTE button	3	Press the MUTE
									on the remote		button to cancel
									control is pressed		the muting effect.
									to ON.	4	Press the
								4	Speakers are not		SPEAKER A or
				OR					switched on.		SPEAKER B
								5	Incorrect		button to ON.
										5
									selection of the		Select the
									input source.		desired input
								6	Incorrect	6	source correctly.
									connections		Make
									between the		connections
									components.		correctly.
	Each time this button is pressed, the						Stations	1	No antenna is	1	Connect an
							cannot be		connected.		antenna.
	brightness changes as follows:
							received	2	The desired	2	Tune in the
	•		ON
									station frequency		desired station
	•		dimmer						is not tuned in.	3	frequency.
	•		OFF					3 The antenna is in			Move the
									wrong position.		antenna and retry
											tuning.
		Note
							Preset	1	An incorrect	1	Memorize the
			If the display is off, pressing any button turns the
			display on.				stations		station frequency		correct station
							cannot be		has been		frequency.
Maintaining								2
							received		The memorized		stations again.
									memorized.	2	Memorize the
To clean this receiver, wipe with a soft, dry cloth.									stations are
									cleared.
If the surfaces are extremely dirty, use a soft
cloth dipped in a soap and water solution or a							Poor FM	1	No antenna is	1	Connect an
weak detergent solution.							reception	2	connected.	2	antenna.
• Never use alcohol, paint thinner, or benzine									The antenna is		Change the
	to clean this receiver.								not positioned for		position of the
									the best		antenna.
• Before using a chemically treated cloth, read
									reception.
	the instructions that came with the cloth
							Continuous	Weak signals.		1	Change the
	carefully.
							hissing				position of the
Troubleshooting							noise during				antenna.
							FM			2	Install an outdoor
If a problem occurs, run through the table below							reception,				FM antenna.
							especially
before contacting Insignia.							when a
If the problem persists, attempt to solve it by							stereo
							broadcast is
switching the receiver off and on again. If this
							received.
fails to resolve the problem, contact Insignia.
Under no circumstances should you attempt to							Continuous	Noise is caused by		1	Keep the receiver
repair the receiver yourself as this could void the							or	motors, fluorescent			away from noise
warranty.							intermittent	lamps, or lightning.			sources.
							hissing			2	Install an outdoor
							noise during				AM antenna.
Category			Problem		Possible Solution
							AM
							reception,
No power			1	The AC power	1	Connect the cord	especially at
				cord is		securely.	night.
				disconnected.	2	Check the outlet
			2				No	1	Incorrect	1	Make
				Poor connection		using a lamp or
							recording		selection		connections
				at AC wall outlet		another
									between the		correctly.
				or the outlet is		appliance.
									components.	2	Operate each
				inactive.				2
									Incorrect		component
									operation of each		correctly.
									component for
									playback and
									recording.

www.insignia-products.com 13