Insignia
Connecting headphones
To connect your headphones:
•Insert the headphone plug into the headphone jack on the receiver.
Notes
•To hear sound from the headphones, make sure the SPEAKER button is set to off.
•When listening to a DTS or Dolby Digital program source, if the headphones are plugged in and the SPEAKER button is set to off, the receiver enters the 2CH downmix mode automatically. For more information, see “2CH downmix mode” on page 27.
•When EXTERNAL IN is selected as an input source, only the front left and front right channel signals can be reproduced through the headphones.
Connecting the power
To connect your receiver to power:
•Plug the power cord into an AC outlet.
Modifying the settings
The On Screen Display setup menu is displayed on the monitor television and allows you to perform the setup procedures. In most situations, you will only need to set this once during the installation and layout of your home theater, and it rarely needs to be changed later.
The On Screen Display setup menu consists of five main menus: system, input, speaker setup, CH level, and sound parameter. These menus are then divided into various
Note
The On Screen Display menu and the momentary
On Screen Display cannot be displayed using the
COMPONENT and the HDMI MONITOR OUTs.
Note
When the video signals are input into the VIDEO IN (composite) and the
Navigating through the setup menu
The explanations here assume you are using the buttons on the remote control when performing the setup menu operation. However, you can use the buttons on the front panel as well. The buttons on the front panel correspond to those on the remote control as shown.
Button on the remote control Button on the front panel
To use the setup menu:
1Press the SETUP button to open the setup menu.
2 Press the selector buttons to select the menu.
3Press the MEMORY/ENTER button to confirm your selection.
Note
During setup menu operation, only the STANDBY(/POWER ON) button and the buttons required for system setup will function.
17 |