Insignia NS-R5101 5.1 Surround Sound A/V Receiver

Category

Problem

Possible Solution

 

 

 

 

 

Poor FM

1

No antenna is

1

Connect an

reception

 

connected.

 

antenna.

 

2

The antenna is

2

Change the

 

 

not positioned for

 

position of the

 

 

the best

 

antenna.

 

 

reception.

 

 

 

 

 

 

Continuous

Weak signals.

1

Change the

hissing

 

 

 

position of the

noise during

 

 

 

antenna.

FM

 

 

2

Install an outdoor

reception,

 

 

 

FM antenna.

especially

 

 

 

 

when a

 

 

 

 

stereo

 

 

 

 

broadcast is

 

 

 

 

received.

 

 

 

 

 

 

 

 

Continuous

Noise is caused by

1

Keep the receiver

or

motors, fluorescent

 

away from noise

intermittent

lamps, or lightning.

 

sources.

hissing

 

 

2

Install an outdoor

noise during

 

 

 

AM antenna.

AM

 

 

 

 

reception,

 

 

 

 

especially at

 

 

 

 

night.

 

 

 

 

 

 

 

 

 

Remote

1

Batteries are not

1

Replace the

control unit

 

installed or do not

 

batteries.

does not

 

have a charge.

2

Remove the

operate.

2

The remote

 

obstacle.

 

 

sensor is

 

 

 

 

obstructed.

 

 

 

 

 

 

 

Specifications

Notes

•Design and specifications are subject to change without notice.

•Weight and dimensions shown are approximate.

•Specifications and external appearance may be changed for the sake of improvement.

Amplifier Power output, stereo mode, 6 Ω, THD 0.7%, 40 Hz~20 kHz: 2×100 W

Total harmonic distortion, 6 Ω, 100 W, 1 kHz: 0.09%

Intermodulation distortion, 60 Hz, 7 kHz= 4:1 SMPTE, 6Ω, 100 W: 0.1 %

Input sensitivity, 47 kΩ, Line (CD, TAPE, VIDEO):

280 mV

Signal to noise ratio, IHF “A” weighted, Line (CD, TAPE, VIDEO): 92 dB

Frequency response Line (CD, TAPE, VIDEO), 20 Hz~50 kHz: +0 dB, -3 dB

Output level

TAPE REC, 2.2 kΩ: 280 mV

PRE OUT (Subwoofer), 1 kΩ:1.0 V

Bass/Treble control, 100 Hz/10 kHz: ±10 dB

Surround mode, only channel driven

Front power output, 6Ω, 1 kHz, THD 0.7%: 125 W / 125

W

Center power output, 6Ω, 1 kHz, THD 0.7%: 125 W

Surround power output, 6Ω, 1 kHz, THD 0.7%: 125 W / 125 W

Digital

Sampling frequency: 32, 44.1, 48, 96 kHz

Audio

 

Digital input level

 

 

Coaxial, 75Ω: 0.5 Vp-p

 

Optical, 660 nm: -15~-21 dBm

 

 

Video

Video format: NTSC

 

 

 

Input sensitivity (=Output level), 75Ω

 

Video (Composite (normal)): 1 Vp-p

 

S-Video (luminance signal): 1 Vp-p

 

(chrominance signal): 0.286 Vp-p

 

Component video (R-Y signal): 0.5 Vp-p

 

(B-Y signal): 0.5 Vp-p

 

(Y signal): 1.0 Vp-p

 

HDMI connector: 19 pin

FM Tuner Tuning frequency range: 87.5~108 MHz

 

Usable sensitivity, THD 3%, S/N 30 dB: 12.8 dBf

 

46 dB quieting sensitivity, mono/stereo: 20.2 / 45.3 dBf

 

 

 

Signal to noise ratio, 65 dBf, mono/stereo: 55 / 50 dB

 

 

 

Total harmonic distortion, 65 dBf,1 kHz, mono/stereo:

 

0.5 / 1.0%

 

 

 

Frequency response, 30 Hz~12 kHz: ±3.0 dB

 

 

 

Stereo separation, 1 kHz: 30 dB

 

 

 

Capture ratio: 4 dB

 

 

 

IF rejection ratio: 80 dB

 

 

AM

Tuning frequency range: 520~1710 kHz

Tuner

 

Usable sensitivity: 500 µV/m

 

 

 

 

Signal to noise ratio: 40 dB

 

 

 

Selectivity: 25 dB

 

 

General

Power supply: 120 V ~ 60 Hz

 

 

 

Power consumption: 3.8 A

 

 

 

Dimensions (W×H×D, including protruding parts):

 

17-3/8×5-1/2×14-3/4 inches (440×141×376 mm)

 

 

 

Weight (Net): 20.5 lbs (9.3 kg)

Legal notices

FCC Part 15

This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced technician for help.

FCC warning

Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user’s authority to operate this equipment.

www.insignia-products.com

31