Integra DSR-4.8 Using the Listening Modes, Theater-Dimensional Listening Angle Setting

Using the Listening Modes—Continued

T-D (Theater-Dimensional) Listening Angle Setting

With this setting, you can specify the angle of the front left and right speakers relative to the listening position. Processing for the Theater-Dimensional listening mode is based on this setting. Ideally, the front left and right speakers should be equidistant from the listening posi- tion and at an angle close to one of the three available settings.

Front left speaker Front right speaker

20/30/40°

1Press and hold the [Setup] but-

ton for 3 seconds.

Remote controller

When selecting the input other than DVD, just press the [Setup] button. “Balance” appears on the display.

HOLD

2	Use the Up and Down [	]/[	]
	buttons to select “Angle”, and
	use the Left and Right [	]/ [	]
	buttons to select: “Narrow”,
	“Middle”, or “Wide”.

Narrow: Select if the listening angle is 20 degrees.

Middle: Select if the listening angle is 30 degrees (default).

Wide: Select if the listening angle is 40 degrees.

3When you’ve finished, press the [Setup] button again.

The setup menu closes.

Note:

Only when the T-D listening mode is selected, this set- ting is available.

Listening Mode and Receiver Settings

Depending on the listening mode, the setup menu settings may be enabled/disabled as shown below.

				✔: available
			Listening Mode
Settings	Page #	Direct	Stereo	T-D
Speaker Output Balance	55	￿	✔	✔
Subwoofer Level	32	￿	✔	✔
Correcting Sound and Picture	55	￿	✔	✔
Sync
Crossover Frequency	56	￿	✔*1	✔
Enabling/Disabling the Subwoofer	55	￿	✔	✔
Front Speakers Size	55	￿	✔*2	✔

*1 During playback a DVD-Audio or SACD, this setting is fixed at 100 Hz. *2 During playback a DVD-Audio or SACD, this setting is fixed at Small.

42