Integra DTR-8.2 Troubleshooting, General Problems, Programming Problems, Recharging Problems

Troubleshooting

General Problems

The display is blank

•Tap the screen to make sure the Remote controller is turned on.

•Adjust the contrast dial on the left side.

•Make sure the batteries are properly installed.

•Install new batteries or recharge the battery pack using the recharging dock.

The display is too light or too dark

•Adjust the contrast dial on the left side.

The Remote controller shuts itself off

•This is a feature of the Remote controller to save power. You can change the length the Remote controller stays on in the Settings (see page 71).

Devices do not respond to commands from the Remote controller

•Make sure the Remote controller is in Use mode (see page 65).

•Make sure the Remote controller’s sending eye is pointed towards the device you are operating.

•Check if the Low Battery icon is blinking. If so, replace the batteries or recharge the battery pack.

•Check if the button you are trying to use is programmed properly (see page 71).

The Remote controller beeps 4 times after inserting the batteries

•Use ChadEdit to update the Remote controller’s software (ChadEdit > Tools > Update)

Programming Problems

Buttons are not sending the correct commands

•Check whether the button is programmed globally or per device (see page 73).

Macros do not work

•Make sure the Remote controller’s sending eye is pointed towards the device the entire time the macro is being executed.

•Insert delays to allow devices to start up properly (see page 77).

•Check if you do not have included inactive buttons in your macro.

•Check if you do not have reprogrammed buttons. Macros can not save commands, they just save buttons. If you reprogram a button, the macro executes the new command assigned to the button.

The TV goes blank or the input source changes

•The Device menu item might be programmed to switch the input source. Operate the device without affecting the input source (see page 70).

The Remote controller will not edit, label or delete commands

•If the label locked appears on the Remote controller icon, the device control panels have been locked to prevent unwanted changes. You cannot modify or delete commands for this device.

•Make sure your devices are positioned as shown on page 72. Avoid programming the Remote controller under bright fluorescent light: it might affect the infrared signals.

•Make sure the button you want to edit has a border. Borderless buttons cannot be programmed.

The Remote controller will not switch modes

•When the batteries are low the Remote controller prevents you from switching to customizing modes so that no customization can get lost. Replace the batteries (see page 63).

The Remote controller is low on memory

•The remote controller displays a message to clean up the memory. The Remote controller will do this by permanently removing devices and macro and timer groups you have deleted.

Warning:

Cleaning up memory will take 10 minutes or longer. Never remove batteries during the clean-up process. This might damage the configuration file resulting in loss of your customized commands.

The configuration file is corrupted

•When this very unlikely event occurs, you have to revert to the original configuration. All your customized commands devices and macros will be lost and you will have to reprogram your remote controller.

Remote controller error messages

•If one of the following error messages occurs, please contact your dealer or the Integra/Onkyo customer service:

•Can not open configuration file

•Configuration file error

•No configuration file found

•Invalid configuration file version

Recharging Problems

The batteries will not recharge

•Make sure you are using the rechargeable battery pack included with your recharging dock and not the AA batteries.

The indicator light blinks

•Check if the contacts on the recharging dock are clean and free of obstructions.

•Make sure the remote controller lies properly on the dock.

•Make sure the battery pack is installed properly in your remote controller (see page 63).

82