Vol. 3 19-29
ARCHITECTURE COMPATIBILITY
may not be implemented or implemented differently in future processors. The
MCE flag in control register CR4 enables the machine-check exception. When this
bit is clear (which it is at reset), the processor inhibits generation of the machine-
check exception.
•General-protection exception (#GP, interrupt 13) — New exception condition
added. An attempt to write a 1 to a reserved bit position of a special register
causes a general-protection exception to be generated.
•Page-fault exception (#PF, interrupt 14) — New exception condition added. When
a 1 is detected in any of the reserved bit positions of a page-table entry, page-
directory entry, or page-directory pointer during address translation, a page-fault
exception is generated.
The following exception was added to the Intel486 processor:
•Alignment-check exception (#AC, interrupt 17) — New exception. Reports
unaligned memory references when alignment checking is being performed.
The following exceptions and/or exception conditions were added to the Intel386
processor:
•Divide-error exception (#DE, interrupt 0)
— Change in exception handling. Divide-error exceptions on the Intel386
processors always leave the saved CS:IP value pointing to the instruction that
failed. On the 8086 processor, the CS:IP value points to the next instruction.
— Change in exception handling. The Intel386 processors can generate the
largest negative number as a quotient for the IDIV instruction (80H and
8000H). The 8086 processor generates a divide-error exception instead.
•Invalid-opcode exception (#UD, interrupt 6) — New exception condition added.
Improper use of the LOCK instruction prefix can generate an invalid-opcode
exception.
•Page-fault exception (#PF, interrupt 14) — New exception condition added. If
paging is enabled in a 16-bit program, a page-fault exception can be generated
as follows. Paging can be used in a system with 16-bit tasks if all tasks use the
same page directory. Because there is no place in a 16-bit TSS to store the PDBR
register, switching to a 16-bit task does not change the value of the PDBR
register. Tasks ported from the Intel 286 processor should be given 32-bit TSSs
so they can make full use of paging.
•General-protection exception (#GP, interrupt 13) — New exception condition
added. The Intel386 processor sets a limit of 15 bytes on instruction length. The
only way to violate this limit is by putting redundant prefixes before an
instruction. A general-protection exception is generated if the limit on instruction
length is violated. The 8086 processor has no instruction length limit.