51
3 Configuration Software and Utilities

This chapter describes the Power On Self Test (POST) and server configuration utilities. The table

below briefly describes the utilities.

Table 4. Configuration Utilities
Utility Description and brief procedure Page
BIOS Setup If the system does not have a diskette drive, or the drive is disabled or
mis-configured, use Setup to enable it.
Or, you can move the CMOS jumper on the server board from the
default setting (Protect CMOS memory) to the Clear setting; this will
allow most server configurations to boot. For the procedure to do this,
see the section “CMOS Jumper” in Chapter 5 in this manual. Then run
the SSU to configure the server.
53
System Setup Utility
(SSU) Use for extended system configuratio n of onboard resources and add-
in boards, and for viewing the syste m event log, setting boot device
priority, or setting system security op tions.
The SSU may be run from either the Server Configuration CD or from
a DOS-bootable diskette.
Information entered via the SSU overrides information entered via
BIOS Setup.
67
EMP Console Use to access and monitor the server remotely. 79
FRUSDR Load Utility Use to update the Field Replacement Unit (FRU), Sensor Data Record
(SDR), and Desktop Management Interface (DMI) flash components. 92
BIOS Update Utility Use to update the BIOS or recover from a corrupted BIOS update. 95
Firmware Update Utility Use to update BMC and HSC flash ROM. 98
Using the Adaptec SCSI
Utility Use to configure or view the settings of the SCSI host adapters and
onboard SCSI devices in the server. 99

Hot Keys

Use the keyboard’s numeric pad to enter numbers and symbols.

Table 5. Hot Keys
To do this: Press these keys
Clear memory and reload the operating
systemthis is a system reset. <Ctrl+Alt+Del>
Secure your system immediately. <Ctrl+Alt>+h otkey (Set your hot key combination with the SSU or
Setup.)