![](/images/new-backgrounds/1187889/18788927x1.webp)
Chapter 2 Installation
Media Compart- ment, cont.
Media Supply Positions
There are four sets of slots and threaded holes in the printer’s center section for the media supply roll post or rotating hub (optional). These slots allow the largest possible roll size to fit, given the limitations of any liner takeup unit and/or the full enclosure provided by the long side door or Megatop. The positions are indicated by numbers engraved in the center section.
•Position 1 is used when the media compartment is fully enclosed by a long side door, regardless of the existence of any integral liner takeup unit. Maximum roll size is 152 mm (6 inches).
•Position 2 is used when the printer has a short side door that only encloses the print mechanism, but does not have an integral liner takeup unit. Maximum roll size is 213 mm (8.38 inches).
•Position 3 is used when the printer has a short side door and an integral liner takeup unit. This position is also used with the optional
•Position 4 is reserved for possible future development.
The printer can also use an external media supply located behind the printer, unless it has an optional
3
Pos. 3
2
1 | Pos. 2 |
| |
| 4 |
| Pos. 1 |
(Pos. 4)
Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 3 | 13 |