Intermec F4 manual Tickets with Black Mark, Maximum Depends on Dram size Minimum 20.0 mm Inches

Appendix 2 Media Specifi cations

Media, cont.

Tickets with Black Mark

a

eb

f

c d g

TICKETS

FEED

DIRECTION

⇐	a ⇒	Media Width:
Maximum:			114.3 mm	(4.50 inches)
Minimum (standard):			25.0 mm	(1.00 inches)
Minimum (narrow Quick-Load):			40.0 mm	(1.57 inches)
Minimum (wide Quick-Load):			80.0 mm	(3.15 inches)
⇐	b ⇒	Copy Length:
Maximum:			depends on DRAM size
Minimum:			20.0 mm	(0.8 inches)

⇐c ⇒ LSS Detection Position:

Five fixed positions (distance from inner edge of the media):

3 mm	(0.118 inches)
8 mm	(0.315 inches)
12 mm	(0.472 inches)
16 mm	(0.639 inches)
20 mm	(0.787 inches)

⇐d ⇒ Black Mark Width:

The detectable width of the black mark should be at least 5.0 mm (0.2 inches) on either side of the LSS detection point.

⇐e ⇒ Black Mark Length:

Maximum:	21.3 mm	(0.83 inches)
Common:	12.5 mm	(0.5 inches)
Minimum:	5.0 mm	(0.2 inches)

⇐f ⇒ Black Mark Y-Position:

It is recommended that you place the black mark as close to the front edge of the ticket as possible and use a negative Stop Adjust value to control the media feed, so the tickets can be properly torn or cut off.

Media Type Setup:

• Mark

The black mark should be non-reflective carbon black on a whitish background. Do not allow any perforations to break the edge of the media as this may cause the media to split and jam the printer.

70 Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 3