Intermec F4 Printhead Cleaning, cont.

Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 352

Chapter 10 Maintenance

Printhead Cleaning, cont.

Wait for approx. 30 seconds to allow the

cleaning ﬂ uid to dissolve the residue. Insert most of the cleaning card under the

printhead (1). Engage the printhead (2).

Allow the cleaned parts to dry before loading

any media and ribbon.

Pull out the cleaning card. If necessary, repeat

the process with a fresh cleaning card.

Contents

Main Contents EasyCoder F4 Installation & Operation IPL Version Edition 3, August 2001 Part No. 1-960490-0 2 Page Contents, cont. Page Declaration of Conformity Introduction Description Safety Precautions Product Labeling Installation Unpacking Front View Rear View Media Compartment Media Compart- ment, cont. 76 mm (3 inches) CORE 38 - 40 mm (1.5 inches) Page Print Mechanism Connections Power Computer Controls and Indicators Control Lamps Display Controls and Indicators, cont. Beeper Keyboard Starting Up Switching On Initializing ::: IPL Ver 1.3 9600-8-N-1-X/X Media Load Tear-Off (Straight-through) Page Tear-Off, cont. Page Tear-Off with Quick-Load (Straight-through) Tear-Off with Quick-Load, cont. Peel-Off (Self-strip) Page Page Page External Supply Ribbon Load Thermal Transfer Printing Ribbon Load, cont. 3 4 5 6 Ribbon Load, cont. 7 8 9 10 Page Setting Up the Printer Description Default Setup Setup Parameters Serial Communication Baud Rate Data Bits Parity Stop Bits Protocol Page Serial Communication, cont. Page Test/Service, cont. Media Media Type Paper Type Label Length Sensitivity Darkness Media, cont. SETUP: COMMUNICATION Entering Setup Mode at Installation Setup Mode - Navigating in Setup Mode Intermec EasyCoder F4 Installation & Operation IPL Version, Ed. 3 43 Chapter 7 Setup Mode Setup Mode Overview, Part 1 Continued on next page Intermec EasyCoder F4 Installation & Operation IPL Version, Ed. 344 Chapter 7 Setup Mode Setup Mode Overview, Part 2 Continued from previous page Continued on the next page if an EasyLAN 100i interface board is installed. Intermec EasyCoder F4 Installation & Operation IPL Version, Ed. 3 45 Chapter 7 Setup Mode Setup Mode Overview, Part 3 Options Introduction Page Quick-Load Guides Label Taken Sensor Interface Boards Intermec EasyCoder F4 Installation & Operation IPL Version, Ed. 3 49 Chapter 9 Troubleshooting Maintenance Printhead Cleaning Page Printhead Cleaning, cont. External Cleaning Cleaning the Media Guides Printhead Replacement Page Printhead Replacement, cont. Narrow Media Adjustment Adjustments Label Stop Sensor Position Printhead Pressure Ribbon Break Shaft Technical Data Technical Data, cont. Media Speci cations Direct Thermal Thermal Transfer Media Roll Size Non-Adhesive Strip Self-Adhesive Strip Self-Adhesive Labels c d Tickets with Gap c f d Tickets with Black Mark f dc g Transfer Ribbons 56 Intermec Setting the Media Sensitivity Number Setting the Media Sensitivity Number, cont. Setting the Media Sensitivity Number, cont. Direct Thermal Media Sensitivity Settings Thermal Transfer Media and Ribbon Sensitivity Settings Interfaces RS-232 Interface IEEE 1284 Parallel Interface Board EasyLAN 100i Interface Board Supported IPL-3 Commands