PB3 LED State Descriptions (continued)
LED | State | Description |
|
|
|
Data and Status | Off | Card was read successfully, or card |
|
| cannot be read (for optional magnetic |
|
| stripe reader). |
|
|
|
| Steady Green | Card reader is ready to accept data (for |
|
| optional magnetic stripe reader). |
|
|
|
| Flashing Red | Printhead is too hot. Printing is paused |
|
| until printhead reaches normal |
|
| operating temperature. |
|
|
|
| Steady Red | One of three conditions: |
|
| • Printer is out of paper. |
|
| • The paper door is open. |
|
| • Card reader error (for optional |
|
| magnetic stripe reader). |
|
|
|
Using the Battery and AC Adapter/Charger
Use Intermec battery model
The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat above 80°C (176°F), or incinerate.
Note: The battery must be cycled several times to achieve maximum capacity. To cycle a battery, fully charge it and then allow a full discharge through normal use. To ensure a full charge, do not operate the printer while charging the battery.
To install the battery
1Slide the battery door latch toward the belt loop knob to unlock the battery door, and open the battery door to an angle of about 90 degrees. Do not force the door all the way open.
2Orient the battery so the arrow points toward the battery contacts in the battery compartment.
4 | PB3 Mobile Printer User’s Guide |
