SECTION 2—INSTALLING

Adjusting the Propel Back Width

NOTE: For this procedure, refer to FIGURE 2.4.

1.Remove the cushion from the back frame. Refer to Installing/Removing the Propel Back Cushion on page 13.

2.Loosen, but DO NOT remove, the two mounting bolts and washers that secure the cane mounting bracket to the back frame.

3.Move the cane mounting brackets to the desired position.

NOTE: Keep the back frame centered for proper positioning.

4.Carefully set the back onto the back tabs.

5.Adjust the mounting brackets on both sides for desired fit keeping back centered.

6.Tighten the mounting bolts securely.

7.Replace the cushion. Refer to Installing/Removing the Propel Back Cushion on page 13.

8.Check the back height, adjust cane mounting bracket if necessary. Refer to Installing Mounting Hardware on page 9.

NOTE: Most wheelchairs’ back canes are not fully vertical. Adjust the width of the brackets on the back frame to match. If the Propel Back seems too loose or too tight, the brackets can be manually adjusted to increase or decrease the amount of effort required to install or remove the back from the chair. This adjustment may also be used to reduce back noise caused by movement in the wheelchair.

Back Frame

Back Latch Bracket (hidden from view)

Cane Mounting

 

Bracket

Mounting Bolts

 

Front

Washers

DETAIL “A” - ADJUSTING

BACK WIDTH

Back

Back Latch Brackets

NOTE: Back canes not shown for clarity.

FIGURE 2.4 Adjusting the Propel Back Width

InTouchPropelBack

12

Part No 1143199

Page 12
Image 12
Invacare 1143199 manual Adjusting the Propel Back Width