Invacare 220 manual Seat and Arms, Removing/Installing/Adjusting the Padded Seat

SECTION 7—SEAT AND ARMS

SECTION 7—SEAT AND ARMS

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service, turn power off and remove key from ignition.

NOTE: Refer to Label Locations on page 11 for pinch point location.

Removing/Installing/Adjusting the Padded Seat

NOTE: For this procedure, refer to FIGURE 7.1.

Removing

1.Fold down seat back. Refer to Folding/Unfolding the Back - Padded Seat Only on page 30.

2.Remove the quick-release pin that secures the seat post to the frame tube.

3.Lift the seat assembly up and away from the frame tube.

Installing/Adjusting Seat Height

1.Lower the seat post on the seat assembly into the frame tube.

2.Align the frame tube mounting hole with one (1) of three (3) seat post mounting holes to achieve desired seat height.

3.Insert the quick-release pin through both the frame tube and the seat post on the seat assembly.

NOTE: Ensure that the detent ball is visible outside the frame tube.

4.Unfold the seat back. Refer to Folding/ Unfolding the Back - Padded Seat Only on page 30.

Seat Back

Padded Seat

Quick-	Seat Post
	Mounting Holes
Release
Pin	Seat Post
Frame Tube	Frame Tube
Mounting Hole

NOTE: Tiller not shown for clarity.

FIGURE 7.1 Removing/Installing/Adjusting

the Padded Seat

Part No. 1125053 29 220