SECTION 12—SCOOTER ACCESSORIES
SECTION 12—SCOOTER
ACCESSORIES
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and remove key from ignition.
NOTE: The crutch/cane holder, safety flag, rear mounted basket and oxygen holder all install into the accessory tube; ONLY one (1) of these may be installed at a time.
Installing/Removing the Crutch/Cane Holder
WARNING
The installation of the crutch/cane holder onto the back of the scooter seat signifi- cantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 12.1.
Installing
1.Install the crutch/cane holder into the accessory tube located on the back of the seat.
2.Install the mounting knob to secure the crutch/cane holder in place. Securely tighten.
3.Align the slot on the base with the hook on the crutch/cane holder and slide base down into position.
Removing
1.Remove the crutch/cane holder from the accessory tube.
2.Remove the mounting knob that secures the crutch/cane holder in place.
3.Remove the crutch/cane holder from the accessory tube.
Part No. 1125053 | 47 | 220 |
