Invacare Atlas manual Installing/Removing Front Riggings

SECTION 4—FRONT RIGGINGS

SECTION 4—FRONT RIGGINGS

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.

Installing/Removing Front Riggings

NOTE: For this procedure, refer to FIGURE 4.1.

Installing

1.Turn the front rigging to the side (open footplate is perpendicular to wheelchair).

2.Install the front rigging hinge plates onto the hinge pins on the wheelchair frame.

3.Push the front rigging toward the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4.Repeat STEPS 1‐3 for the opposite side of the wheelchair.

5.To release the front rigging, push the footrest release lever inward, rotate footrest outward.

Removing

1.Push the release lever inward and rotate the front rigging outward.

Release Lever

Swingaway

Footrest

Hinge Pins

Hinge Plates

Footplate

FIGURE 4.1 Installing/Removing Front

Riggings

2.Lift up on front rigging and remove from the wheelchair.

3.Repeat STEPS 1‐2 for the opposite side of the wheelchair.

Atlas™ 22 Part No. 1130169