Invacare Atlas manual SEAT-TO-FLOOR Height, Changing Seat-To-Floor Height

SECTION 10—SEAT-TO-FLOOR HEIGHT

SECTION 10—SEAT-TO-FLOOR HEIGHT

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.

Changing Seat-To-Floor Height

WARNING

Seat-to-floor heights have specific positions depending on rear wheel size, rear wheel position, and front caster position. These adjustments MUST be performed by a qualified technician.

NOTE: For this procedure, refer to FIGURE 10.1.

1.Refer to the following chart and to FIGURE 10.1 to determine mounting positions for front casters/forks and rear wheels for the desired seat‐to‐floor height.

SEAT-TO-FLOOR	8-INCH FRONT	REAR	REAR WHEEL
HEIGHT	CASTER MOUNTING	WHEEL SIZE	MOUNTING
(IN INCHES)	POSITION		POSITION
19	Top	24-inch	Top
20	Bottom	24-inch	Bottom

2.Remove the rear wheels from the wheelchair. Refer to Removing/Installing Rear Wheels on page 26.

3.Remove the front casters from the wheelchair. Refer to Adjusting Front Caster Height on page 27.

4.Reinstall the rear wheels onto the wheelchair in the mounting position indicated in the chart. Refer to Removing/Installing Rear Wheels on page 26.

5.Re‐install the front casters onto the wheelchair in the mounting position indicated in the chart. Refer to Adjusting Front Caster Height on page 27.

Rear Wheel Mounting	Fork Mounting Positions
Positions

Top

Bottom

Top

Bottom

FIGURE 10.1 Changing Seat-To-Floor Height

Atlas™ 30 Part No. 1130169