Invacare CT7A Adjusting Quad-Release Handle In and/or Out, Removing Play from Rear Wheels

11 WHEELS

6.Flip the handle of the quad-release axle down to release the detent pin ensuring that the locking pins are fully released.

7.Repeat the above procedures until the quad-release axle locks correctly.

Adjusting Quad-Release Handle In and/or Out Removing Play from Rear Wheels

Locking Pins

Quad Release

Handle

Locking

Screw

Adjusting Locknut

(On Quick-Release Axle)

Camber Bar	Length
	Adjustment
	Screw
	FIGURE 4 Adjusting Quad-Release Handles

Removing Play from Rear Wheels

1.With the rear wheel and quad-release axle still mounted onto the wheelchair, make the following adjustment:

• Tighten the length adjusting screw until there is no in and out movement of the quad-release axle and rear wheel.

11.5 Handrim Replacement

1.Remove the rear wheel from the wheelchair. Refer to Removing/Installing Rear Wheels on page 62.

￿ WARNING

Tire MUST be fully deflated before any disassembly procedures are performed. Otherwise injury or damage may result.

2.Remove all air from the tube by pressing down on the pin in the center of the valve stem.

3.While carefully holding the tire, tube and rim strip to one side, hold the allen screws and remove the locknuts that secure the handrim to the rear wheel.

Part No 1167484 65 Invacare® Crossfire™T7A Wheelchair