Invacare CT7A user manual Repositioning the Camber Tube Clamps

11 WHEELS

Repositioning the Camber Tube Clamps

1.Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.

2.Loosen, but DO NOT remove, the four socket screws and washers that secure the two camber tube clamps to the camber tube supports.

3.Slide the camber tube forward or backward to adjust the wheelbase length to the desired position.

Ensure that both camber tube clamps are adjust to the same position in the camber tube support. This will ensure that the camber tube remains at 90° to each side frame.

4.Securely tighten the four socket screws and washers that secure the two camber tube clamps to the camber tube supports.

5.Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.

Camber Tube Support

Socket Screws and

Camber

Washers

Tube Clamp

Camber

Tube

FIGURE 8 Repositioning the Camber Tube Clamps

Part No 1167484 69 Invacare® Crossfire™T7A Wheelchair